calculating intrinsic viscosity from melt flow index

If not, gel permeation chromatography is warranted.The molecular weight of a polymeric or biological material usually has a direct effect on its mechanical properties, thermal behavior, and viscosity characteristics. In order for the equation above to be valid, the authors’ note, the viscosity at the MFI conditions normalized by the zero shear viscosity should be a constant for the polymers in a given family. The authors cautioned that this relationship becomes tenuous with polymers having variability in branching and polydispersity index. In a later article, Bremner found x values between 3.4 and 3.7. Given the inverse relationship between MFI and viscosity, it is logical to see that the MFI has a relationship to molecular weight as follows, which has been shown empirically for linear polymers: īremner and Rudin found values of LLDPE had G values ranging from 2x10 -20 to 1x10 -24 (10 min/g (x+1)(mol x)), and x ranged from 3.9-4.6. For polymer melts, the zero-shear viscosity h 0 (or the viscosity at very low shear rates) has a relationship to the weight averaged-molecular weight as follows: As a result, the MFI has a direct correlation to the polymer's melt viscosity. In MFI testing, the polymer is not dissolved in a solvent, but rather is tested in the melt state. Both these techniques involve dissolving the polymer in a good solvent to form a dilute solution, so that individual polymer chains can be interrogated directly (in the case of GPC) or indirectly (in the case of viscosity modification in dilute solution viscometry). How does MFI correlate to the molecular weight of a polymer? At CPG, we often measure molecular weight by gel permeation chromatography or dilute solution viscometry. It is easy to see that lower viscosity materials will result in a higher MFI, since more material can be extruded for a given amount of time. This mass, normalized by time, provides the MFI. The amount of material extruded through the die at the bottom of the annulus is measured by weight for a measured period of time. A plastometer consists of a temperature-controlled cylindrical annulus through which a polymer melt is extruded by pressurization with a weight-loaded piston. This testing is normally performed per ASTM D1238 or ISO 1133 using a plastometer. The certificate of analysis for polymer resins often includes a melt flow index (MFI) or melt flow rate (MFR), reported as grams of material/10 min under a specified temperature and load.

Calculating intrinsic viscosity from melt flow index